English
Español 
Português 
русский 
Français 
日本語 
Deutsch 
tiếng Việt 
Italiano 
Nederlands 
ภาษาไทย 
Polski 
한국어 
Svenska 
magyar 
Malay 
বাংলা ভাষার 
Dansk 
Suomi 
हिन्दी 
Pilipino 
Türkçe 
Gaeilge 
العربية 
Indonesia 
Norsk 
تمل 
český 
ελληνικά 
український 
Javanese 
فارسی 
தமிழ் 
తెలుగు 
नेपाली 
Burmese 
български 
ລາວ 
Latine 
Қазақша 
Euskal 
Azərbaycan 
Slovenský jazyk 
Македонски 
Lietuvos 
Eesti Keel 
Română 
Slovenski 
मराठी 
Srpski језик
Maintenance of plastic shredder
2021-07-13
1. The plastic shredder should be placed in a ventilated position to ensure the working heat of the motor is dissipated and extend its life.
2. Lubricating oil should be added to the bearings regularly to ensure the lubricity between the bearings.
3. Regularly check the cutter screws. After using the new plastic grinder for 1 hour, tighten the screws of the movable knife and the fixed knife with tools to strengthen the fixation between the blade and the knife holder.
4. In order to ensure the sharpness of the cutting of the cutter, the cutter should be checked frequently to ensure its sharpness and reduce unnecessary damage to other parts caused by the blunt blade.
5. When changing the knife, the gap between the movable knife and the fixed knife: 0.8MM for crushers above 20HP is better, and 0.5MM for crushers below 20HP is better. The thinner the recycled material, the larger the gap can be appropriately adjusted.
6. Before starting for the second time, the remaining scraps in the machine room should be removed to reduce the starting resistance. The inertia cover and the pulley cover should be opened regularly, and the ash outlet under the flange should be cleared. The powder discharged from the plastic grinder chamber enters the shaft bearing.
2. Lubricating oil should be added to the bearings regularly to ensure the lubricity between the bearings.
3. Regularly check the cutter screws. After using the new plastic grinder for 1 hour, tighten the screws of the movable knife and the fixed knife with tools to strengthen the fixation between the blade and the knife holder.
4. In order to ensure the sharpness of the cutting of the cutter, the cutter should be checked frequently to ensure its sharpness and reduce unnecessary damage to other parts caused by the blunt blade.
5. When changing the knife, the gap between the movable knife and the fixed knife: 0.8MM for crushers above 20HP is better, and 0.5MM for crushers below 20HP is better. The thinner the recycled material, the larger the gap can be appropriately adjusted.
6. Before starting for the second time, the remaining scraps in the machine room should be removed to reduce the starting resistance. The inertia cover and the pulley cover should be opened regularly, and the ash outlet under the flange should be cleared. The powder discharged from the plastic grinder chamber enters the shaft bearing.
7. The machine should be well grounded.
8. Regularly check whether the belt of the plastic shredder is slack, and adjust it in time.
Previous:Plastic crushing process
